ndiswrapper works fine with the XP Windows drivers, however there seems to be an issue with the signal strength in that it seems to be lower than expected. Security not testedįull name : Wireless G+ MIMO USB Adapter. Works with ndiswrapper using NetMW14x Windows Drivers. Works ok with bcm43xx native driver but need firmware. Works on Breezy using Ndiswrapper after some tweaking: see Ndiswrapper Wiki Works with ndiswrapper using NetMW14x.inf Windows Drivers (Tested on Hardy with wpa2 Personal) I say out of the box, it didn't appear to work instantly but when I rebooted the next day it came to life with no prompting and asked if I'd like to connect to my home network. Worked out of the box on Ubuntu 8.10, including WPA. bcmw15a.inf can be found as part of R74092us.exe. To find your router's frequency use iwlist scan. Must manually set frequency to that of your router using sudo iwconfig channel. Works out of the box in Ubuntu 6.06 (Dapper Drake)Ītheros AR5212 (labeled as Atheros AR2413a-001) Installed with netmw14.inf file from driver cd packaged with card on Ubuntu 10.10 NetAni.inf file download available from site in a tar.gz form. See Truemobile 1350 belowįollow instructions at Welcome to Ubuntu for installation instructions. It is recognized by Ubuntu as Broadcom Corporation BCM4306 80211b/g Wireless Lan Controler. My computer would intermittently freeze for 5 seconds, but this is rare after I stopped Network Manager (sudo /etc/dbus-1/event.d/26NetworkManagerDispatcher stop) got my network's SSID (iwlist wlan0 scan) and configured the interface (sudo iwconfig wlan0 essid ) After installing the driver, use the command "ndiswrapper -a" to link the driver to the card. Works in Feisty with ndiswapper-utils and the Realtek Windows driver (net8185.inf). Need ndiswapper-utils and the Windows driver (BLKWGN.inf). WEP working out of the box with Hardy (8.04) Needs ndiswrapper-utils and the broadcom windows driver (belkin one doesn't seem to work). Alternatively, see Linksys WPC54GS with Speed Boost below. In Hoary, also change the value of radiostate from 1 to 0. Must install ndiswrapper-utils and your windows driver. Recognized by Dapper, but must use bcm43xx-fwcutter to get the firmware. Works well, after editing file Bel6020.inf to change every reference of Bel6020.sys to rtl8180.sys. Does not work on Dapper, or any kernel later than 2.6.12.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |